Facts & Specifications

HowSonicSolutions® Ultrasonic Algae Control Device Kills and Controls Algae

Easy to Install and Maintain

Sonic Algae Control Unit Placement

The SonicSolutions® Ultra-Sonic Algae Control device emits ultrasonic waves that "fan out" at approximately 180℉ from the front of the transducer (see Figure 1). The nutrient level, turbidity, shape of the body of water and the closeness to the equator may affect the coverage area. The potential coverage for the SS 400 model can be as much as 1.5 acres and for the SS 500 model up to 3 acres.

Set up your device to provide the optimal exposure of the ultrasonic waves to the body of water you are treating. Place close to the edge as sonic waves extend only in front of the transducer unit. Large installations and certain shapes of ponds or lakes may require installation of more than one device. Multiple devices can be installed at opposite sides of a lake or pond attached together pointing in different directions, depending on your site requirements.

The SonicSolutions® device, like all ultrasonic devices, is a "line of sight" technology. Ultrasonic sound waves will not go around corners or navigate around islands that may be in your body of water, affecting the efficiency of algae control in ponds and lakes. In such circumstances, additional units are used to cover the "blind spots". Ultrasonic sound waves reflect or bounce off hard surroundings, such as concrete, rip-rap, and large rocks (see Figure 3).

*24 volt units are compatible with any 24 volt DC power source: 1) Battery (require a minimum of two 105 deep cycle 12V batteries wired in series) 2) Irrigation system 3) Solar Power System, which includes two batteries, may be purchased separately from SonicSolutions)